The Nooksack Valley Fruit and Produce Company Co. project is moving forward in fits and starts, but at not much above glacial speed. As a total aside, you can follow my wife and me on our
garden project here, which helps explain my slowing down on the railroad. The lead photo here shows the current state of the building. Its wall color has been finalized, the basic roof is in place, and the loading dock is finished. In this post I will discuss some of these steps and list the remaining steps to finally wrap up this project.
I left off my last
post on this project with the walls built, but unsure of the color to paint the bricks. It took a couple of attempts. First I sprayed the completed walls with a rattle-can primer in a khaki color. After that had dried I started to sponge on some acrylic craft paint off-white and tan colors. As I was really unhappy with the look, I stopped part way through and cleaned off as much of it as I could with a damp paper towel before it had a chance to set up. The next day I masked the concrete foundation with painter's tape and sprayed with a white rattle-can lightly over the walls. I stopped short of complete or even thorough coverage to allow some subtle variation. While out in the garage with spray paints, I sprayed the doors and windows with a dark green primer. After yet another overnight drying session, I applied several light applicatiions of Vallejo Wash colors; I just touched the saturated brush tip to the wall allowing the wash to flow through the mortar lines. I finally had something close to the subtly worn white, painted brick look I had envisioned.
While I had been using the scratchbuilt loading dock from another building for my planning, I wanted to build one specific to this building. After taking some measurements, I drew up plans for this one and created a cut list for the strip wood needed. I cut the pieces to length with either my Zona razor saw or on the Chopper. (Something happened while cutting the deck boards on the Chopper as later I found them to have length variations.) After they were cut, I stained them with Hunterline Cordovan Brown weathering mix. Later when I started assembling the dock, I tried a new technique that I picked up from a
Thunder Mesa Studio video by Dave Meek. Instead of building on the drawing covered by wax paper, add another layer to allow for a fixture technique. Tape the drawing to a piece of foamcore before covering it with wax paper, so that a starting piece can be pegged into place with pins. That provides a rigid piece to fit and glue the other pieces to. This photo shows this technique in use as I glued up the frame for the dock. While gluing on the deck boards, I used a metal block lined up with one of the long deck frame boards to keep the decking boards even on that side. After the glue dried, I went back and turned the deck upside down and trimmed some of the longer decking back with a chisel-bladed hobby knife. That, some sanding, and gouging with a hobby knife, turned inaccurate cutting into part of the weathering of a well-worn loading dock!
To wrap up this slow moving building project I need to:
- Finalize the roof; maybe paint, maybe tar paper.
- Decide on coping for the top of the walls, then apply and paint
- Window glazing and any interior
- Roof over loading dock
- Lighting
- Signage
