Curtis Cannery Continued

Since my last post I have continued to work on the main parts of the cannery, starting with the Walthers background kit and some blocks of wood. Two friends from the Alleghany Western Division influenced me here. Dick Bradley sent me an email about my last post suggesting that he wasn't sure about the proportions of the warehouse size to the main cannery building. In his view the adjacent warehouse appears too large compared to the main structure. While the size of the brick portion of the main structure is settled with my choice of kit to kitbash, I did increase the size of the wooden portion. If after the main portion is completed I agree that the warehouse is too large, I may change it. My criticism of it is not it's size, but that it is one of the ubiquitous Walthers kits that everyone recognizes as a model railroad building. Bill Schopf, also from my old division, popularized using wooden blocks as the core of models in several clinics when I was still in Division 12 of the MCR. While I haven't decided exactly how the scratchbuilt structure portions will come together, I am pretty sure of the size and shape depicted by the wooden blocks depicted here. After cutting the two blocks I started on the brick portion of the cannery.

My first step was to make a few adjustments to the Arrowhead Ale background kit to increase the depth of the building. As I was planning to scratchbuild a wood loading dock I cut off that portion of the supplied plastic base. I also cut out a portion of an extra wall piece included in the kit to model the deeper exposed end. For the other end, I cut a section of plain styrene sheet to match the depth. I cut some strip styrene to extend the base under the deeper sides. Having a supply of various sizes of styrene on hand made the fitting of kitbashed parts easier than if I had to order online or drive for hours to shop at the nearest brick and mortar train/hobby store. 

After assembling the building with Bondene, the next step was painting. Heading out to the garage, I sprayed the walls with a gray rattle can primer. At the same time I removed the doors and windows from the sprue and mounted them with blue painter's tape on a paint stick before spraying them with a green rattle can primer. After the building had dried overnight, I started painting the brick portions with three or four different red and brown craft paints over the gray primer with a small piece of natural sponge. It looks like a mottled mess until several coats have been sponged on. I also painted some of the individual blocks of the foundation with a mix of gray and tan craft paints. I applied Vallejo's dark gray wash as a control coat and mortar color to the bricks and foundation. 

Once the paint had all dried and set up, I glued the door and window castings in place. The one finished side that I had scavenged from the extra casting had several issues. The appropriate door casting with a transom was not included, so I ended up using one without a transom and boarding up the gap with strip wood. Also, because the two upper windows at that end were aligned with the roof, I trimmed some brick wall scrap to fill those openings. I then measured and cut a heavy piece of sheet styrene for the roof, sprayed it with the gray primer, and glued it into place. As seen in the photo, I made sure that it was square and braced it with some heavy strip styrene to ensure that this portion of the building was stabile in spite of being a three-sided flat.

This photo shows the brick portion of the cannery in place as it currently stands. I have a couple of scratchbuilt additions to add: the wooden loading dock, as well as a water tank and a stair bulkhead on the roof. Also, the roof needs some kind of "texture" beyond the paint. The windows need glazing, and I need to decide if I will add any lighting to this portion of the building. Finally, in looking at the photos, I see the need for some touch up of the trim/concrete sills.